LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Mechanical Brake System - Base (Service Information)) >> Brakes - Base >> Disc Brake Caliper Adapter >> Removal

Disc Brake Caliper Adapter: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the front wheel and tire assembly.
  3. Drain a small amount of fluid from master cylinder brake reservoir with a clean  suction gun.
  4. Bottom the caliper pistons into the caliper by prying the caliper over.
  5. Remove the caliper mounting bolts. See Figure.
  6. Remove the disc brake caliper from the mount.
    CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.
  7. Remove the inboard and outboard brake pads. (Refer to BRAKES/HYDRAULIC/MECHANICAL/BRAKE PADS/SHOES - REMOVAL) .
  8. Remove the caliper adapter mounting bolts. See Figure.
scientia non olet · About LEMON Manuals