LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Mechanical Brake System - Base (Service Information)) >> Brakes - Base >> Brake Lines >> Removal >> Rear Brake Hose

Rear Brake Hose

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Brake Hose At The Body
GC0025463Courtesy of DAIMLERCHRYSLER CORP.
1 - MOUNTING BOLT
2 - BRAKE HOSE
3 - BRAKE LINE
4 - COIL SPRING
  1. Install prop rod on the brake pedal to keep pressure on the brake system.
  2. Raise and support the vehicle.
  3. Remove the brake line (3) from the hose (2) at the body. See Fig 1.
  4. Remove the brake hose mounting bolt (1) at the top of the hose located at the body. See Fig 1.
    Fig 2: Brake Hose At The Axle
    GC0025462Courtesy of DAIMLERCHRYSLER CORP.
    1 - REAR WHEEL SPEED SENSOR
    2 - BRAKE HOSE
    3 - VENT HOSE
    4 - BRAKE LINES
    5 - MOUNTING BOLT
  5. Remove the vent tube (3). See Fig 2.
  6. Remove the two brake lines (4) at the bottom of the hose located at the axle. See Fig 2.
  7. Remove the mounting bolt (5) for the brake hose (2) at the axle. See Fig 2.
  8. Remove the hose (2).
scientia non olet · About LEMON Manuals