LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Mechanical Brake System - Base (Service Information)) >> Brakes - Base >> Brake Junction Block >> Installation

Brake Junction Block: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Junction Block
GC0025489Courtesy of DAIMLERCHRYSLER CORP.
1 - INNER FENDER
2 - JUNCTION BLOCK
3 - MOUNTING NUT
  1. Install the junction block (2) on the mounting studs.
  2. Install mounting nuts (3). Tighten to 14 N.m (125 in. lbs.).
  3. Install brake lines to the junction block (2) and tighten to 20 N.m (180 in. lbs.). See Fig 1.
  4. Bleed the brake system (Refer to BRAKES - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals