LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (HVAC Systems) >> Distribution >> Blower Motor >> Installation

Blower Motor: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align and install the blower motor into the HVAC housing.
  2. Rotate the blower motor until all of the locking tabs have secured the blower motor to the HVAC housing.
    NOTE: Failure to install the blower motor correctly could result in an air leak or the blower motor becoming completely disengaged from the HVAC housing.
  3. Connect the wire harness connector to the blower motor.
  4. Reconnect the negative battery cable.
  5. Test the blower motor for proper installation by operating the blower motor at its fastest speed while checking around the outer edges of the blower motor and HVAC housing for air leaks. If any are found, remove and reinstall the blower motor.
scientia non olet · About LEMON Manuals