LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (HVAC Systems) >> Controls >> Blower Motor Resistor >> Installation

Blower Motor Resistor: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the blower motor resistor into the HVAC housing.
  2. Install the two screws that secure the blower motor resistor to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the wire harness connector to the blower motor resistor.
  4. Push in the lock on the blower motor resistor wire harness connector.
  5. Close the glove box door.
  6. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals