Blower Motor Resistor: Description
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
The blower motor resistor is mounted to the rear of the HVAC housing, directly behind the glove box. The blower motor resistor consists of a molded plastic mounting plate with an integral wire connector receptacle. Concealed behind the mounting plate is the resistor circuit board. See Fig 1.
The blower motor resistor is accessed for service by opening the glove box.
| 1 - MOUNTING PLATE |
| 2 - WIRE HARNESS CONNECTOR |
| 3 - HEAT SINK |