Blower Motor Relay: Removal

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Open the cover of the power distribution center (PDC) located in the engine compartment. See Fig 1.
NOTE: Refer to the fuse and relay layout map on the PDC cover for blower motor relay location.
Remove the blower motor relay from the PDC.

Fig 1: Power Distribution Center (PDC) - LHD shown, RHD similar

Courtesy of DAIMLERCHRYSLER CORP.

1 - POWER DISTRIBUTION CENTER (PDC)

2 - BATTERY