LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 497 (HVAC Systems) >> Controls >> A/C Low Pressure Switch >> Installation

A/C Low Pressure Switch: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the A/C low pressure switch fitting.
  2. Install the A/C low pressure switch on the accumulator. Hand-tightened the switch securely.
  3. Connect the wire harness connector to the A/C low pressure switch.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals