A/C High Pressure Switch: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
- Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the A/C high pressure switch fitting.
- Install the A/C high pressure switch onto the A/C discharge line. Hand-tightened the switch securely.
- Connect the wire harness connector to the A/C high pressure switch.
- Reconnect the negative battery cable.