LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 496 (Emissions Control System) >> Evaporative Emissions >> Pump-Natural Vac Leak Detection >> Installation

Pump-Natural Vac Leak Detection: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install NVLD pump to mounting bracket (snaps on).
  2. Carefully install vapor/vacuum lines to NVLD pump. The vapor/vacuum lines and hoses must be firmly connected. Check the vapor/vacuum lines at the NVLD pump, filter and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set. 
  3. Connect electrical connector to pump.
  4. If equipped, install fuel tank skid plate.
scientia non olet · About LEMON Manuals