LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> Water Pump >> Removal >> 2.4L Engine

2.4L Engine

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative cable from battery.
  2. Raise vehicle on a hoist.
  3. Remove the accessory drive belts (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  4. Remove the belt tensioner.
  5. Drain the cooling system (Refer to COOLING - STANDARD PROCEDURE) .
  6. Remove the generator.
  7. Remove the power steering pump.
  8. Remove the A/C compressor.
  9. Remove the accessory drive bracket.
  10. Remove the timing belt (Refer to ENGINE/VALVE TIMING/TIMING BELT AND SPROCKET(S) - REMOVAL).
  11. Remove timing belt idler pulley.
  12. Hold camshaft sprocket with Special tool C-4687 and adaptor C-4687-1 while removing bolt. Remove both cam sprockets.
  13. Remove the timing belt rear cover (Refer to ENGINE/VALVE TIMING/TIMING BELT COVER(S) - REMOVAL).
  14. Remove water pump to engine attaching screws. See Fig 1.
Fig 1: Water Pump
GC0021856Courtesy of DAIMLERCHRYSLER CORP.
1 - CYLINDER BLOCK
2 - WATER PUMP
scientia non olet · About LEMON Manuals