LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Engine Cooling System & Automatic Transmission Cooling System) >> Engine >> Radiator >> Installation >> 3.7L/2.8L Diesel Engines

3.7L/2.8L Diesel Engines

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before installing the radiator or A/C condenser, be sure the radiator-to-body and radiator-to-A/C condenser rubber air seals are properly fastened to their original positions. These are used at the top, bottom and sides of the radiator and A/C condenser. To prevent overheating, these seals must be installed to their original positions.
  1. Gently lower the radiator and fan shroud into the vehicle. Guide the two radiator alignment dowels into the rubber grommets located in lower radiator crossmember.
  2. Connect the radiator upper and lower hoses and hose clamps to radiator.
    CAUTION: The tangs on the hose clamps must be positioned straight down.
  3. Install coolant reserve/overflow tank hose at radiator.
  4. Install both radiator mounting bolts.
  5. Reconnect the electric cooling fan.
  6. Install the grill (Refer to BODY/EXTERIOR/GRILLE - INSTALLATION) .
  7. Reinstall the cooling fan to the engine.
  8. Rotate the fan blades (by hand) and check for interference at fan shroud.
  9. Refill cooling system (Refer to COOLING - STANDARD PROCEDURE) .
  10. Connect battery cable at battery.
  11. Start and warm engine. Check for leaks.
scientia non olet · About LEMON Manuals