Clutch Pedal: Removal
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CYLINDER |
| 2 - ACTUATOR SHAFT |
| 3 - PEDAL PIN |
| 4 - ACTUATOR EYE |
| 5 - CONNECTOR |
- Remove steering column lower cover and knee blocker for access.
- Disconnect clutch pedal position switch wires.
- Disengage bushing lock tabs attaching clutch master cylinder actuator (4) to pedal pivot (3). See Fig 1.
- Remove nuts attaching pedal and bracket to dash panel and upper cowl support.
- Separate pedal assemble from vehicle.