Clutch Pedal: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CYLINDER |
| 2 - ACTUATOR SHAFT |
| 3 - PEDAL PIN |
| 4 - ACTUATOR EYE |
| 5 - CONNECTOR |
- Place clutch pedal and bracket over studs on dash panel and cowl support.
- Install pedal and bracket to dash panel nuts and tighten to 39 N.m (29 ft. lbs.).
- Engage captured bushing (4) and actuator on brake pedal pivot (3). See Fig 1.
- Connect clutch pedal position switch wires (5).