Front Axle - 186FIA: Differential: Disassembly
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - THRUST WASHER |
| 2 - SIDE GEAR |
| 3 - PINION MATE GEAR |
- Remove ring gear.
- Remove roll-pin holding mate shaft in housing.
- Remove pinion gear mate shaft.
- Rotate differential side gears (2) and remove pinion gears (3) and thrust washers (1). See Fig 1.
- Remove differential side gears and thrust washers.