Front Axle - 186FIA: Bearing-Axle: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - INSTALLER 8806 |
| 2 - HANDLE C-4171 |
- Install new shaft bearing with Installer 8805 and Handle C-4171.
- Apply a light coat of lubricant on the lip of the shaft seal.
- Install new shaft seal with Installer 8806 (1) and Handle C-4171 (2). See Fig 1.
- Install right axle shaft if removed.
- Install half shaft.