Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TEST REFERENCE - P1790-FAULT IMMEDIATELY AFTER SHIFT
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Low fluid level can be the cause of many transmission problems. If the fluid level is low locate and repair the leak then check and adjust the fluid level per the Service Information.
NOTE:
Always perform diagnostics with a fully charged battery to avoid false symptoms. With the DRBIII®, read the engine DTC's. Check and repair all engine DTC's prior to performing transmission symptom diagnostics.With the DRBIII®, read Transmission DTC's. Record all DTC's and 1 Trip Failures.
NOTE:
Diagnose 1 Trip Failures as a fully matured DTC. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Repair as necessary.Perform the Shift Lever Position Test. If the test does not pass, refer to Symptom test for P0706 CHECK SHIFTER SIGNAL .For Gear Ratio DTC's, check and record all CVI's.Most DTC's set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run.
NOTE:
Verify the flash level of the transmission controller. Some problems are corrected by software upgrades to the transmission controller.
NOTE:
Check for applicable TSB's related to the problem. Perform this procedure prior to Symptom diagnosis.ContinueGo To 2 |
All |
| 2 | This DTC is set along with a speed ratio DTC. Check 1 trip failures if there are no speed ratio DTC's that are current. If there are no possible causes remaining, view repair. Repair This DTC is set if an associated speed ratio DTC is stored within 1.3 seconds after a shift. Refer to the TRANSMISSION CATEGORY and perform the appropriate speed ratio symptom. Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1 . |
All |