LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Vehicle Theft/Security >> Symptom: SIREN BATTERY HAS BEEN TAMPERED (EXPORT ONLY) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - SIREN BATTERY HAS BEEN TAMPERED

TEST ACTION APPLICABILITY
1 Inspect the wiring harness to the siren for any signs of tampering or damage.
Were there any problems found?
Yes --> Repair wiring as necessary.
Perform VTSS VERIFICATION TEST - 1A  .
No --> Go To 2		 All
2 With the DRBIII®, erase the current Intrusion Transceiver Module DTC's.
Turn the ignition off.
Arm the VTSS and wait 1 minute.
Disarm the VTSS and turn the ignition on.
With the DRBIII®, read Intrusion Transceiver Module DTC's.
Does the DRBIII® display: Siren Battery Has Been Tampered?
Yes --> Replace the Siren in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1  .
No --> The condition that caused this symptom is currently not present.
Inspect the related wiring harness for a possible intermittent condition. Look for any chafed, pierced or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1  .		 All
scientia non olet · About LEMON Manuals