LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Vehicle Theft/Security >> Symptom: ITM - VIN MISMATCH (EXPORT ONLY) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - VIN MISMATCH

TEST ACTION APPLICABILITY
1
NOTE: Do not attempt to use either an ITM and/or a Siren from another vehicle.
With the DRBIII® display and record the VIN in the Intrusion Transceiver Module.With the DRBIII® select Body Computer.Display and record the VIN in the BCM.With the DRBIII® select Engine.Display and record the VIN in the PCM.Does the VIN in the ITM and the VIN in the BCM match the VIN in the PCM?Yes --> Go To 2No --> Replace the Module(s) with the incorrect VIN.Perform BODY VERIFICATION TEST - VER 1  .		 All
2 With the DRBIII®, erase the current Intrusion Transceiver Module DTC's.
Turn the ignition off.
Arm the VTSS and wait 1 minute.
Disarm the VTSS using the RKE and turn the ignition on.
With the DRBIII®, read Intrusion Transceiver Module DTC's.
Does the DRBIII® display: ITM VIN Mismatch?
Yes --> Replace the Intrusion Transceiver Module.
Perform BODY VERIFICATION TEST - VER 1  .
No --> The condition that caused this symptom is currently not present.
Test complete.
Perform BODY VERIFICATION TEST - VER 1  .		 All
scientia non olet · About LEMON Manuals