LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Vehicle Theft/Security >> Symptom: ITM - TRANSDUCER FAILURE (EXPORT ONLY) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - TRANSDUCER FAILURE

TEST ACTION APPLICABILITY
1 With the DRBIII®, erase the current Intrusion Transceiver Module DTC's.
Turn the ignition off.
Arm the VTSS and wait 1 minute.
Disarm the VTSS and turn the ignition on.
With the DRBIII®, read Intrusion Transceiver Module DTC's.
Does the DRBIII® display: ITM Transducer Failure?
Yes --> Go To 2
No --> The condition that caused this symptom is currently not present.
Test complete.
Perform BODY VERIFICATION TEST - VER 1  .		 All
2 Inspect the louvers of the Intrusion Transceiver Module for blockage from dust or debris.
Were there any problems found?
Yes --> Clean as necessary.
Perform VTSS VERIFICATION TEST - 1A  .
No --> Replace the Intrusion Transceiver Module.
Perform BODY VERIFICATION TEST - VER 1  .		 All
scientia non olet · About LEMON Manuals