LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Vehicle Theft/Security >> Symptom: *HEADLAMPS FAIL TO FLASH WITH VTSS >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - HEADLAMPS FAIL TO FLASH WITH VTSS

TEST ACTION APPLICABILITY
1 Turn the Low Beam Headlamps on.
Do the Low Beam Headlamps operate properly?
Yes --> Go To 2
No --> Refer to symptom LOW BEAM HEADLAMPS WILL NOT TURN ON .
Perform VTSS VERIFICATION TEST - 1A  .		 All
2 With the DRBIII® in Miscellaneous check the Body Control Module country code setting.
Is the country code correct?
Yes --> Replace and program the Body Control Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Program the correct country code setting.
Perform VTSS VERIFICATION TEST - 1A  .		 All
scientia non olet · About LEMON Manuals