LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Power Door Locks/RKS >> Symptom: *ALL PASSENGER DOORS FAIL TO LOCK AND UNLOCK >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - ALL PASSENGER DOORS FAIL TO LOCK AND UNLOCK

TEST ACTION APPLICABILITY
1 With the DRBIII®, read DTCs.
Are there any Power Door Lock related codes present?
Yes --> Refer to POWER DOOR LOCKS/RKE .
Perform BODY VERIFICATION TEST - VER 1  .
No --> Go To 2
All
2 Remove the Door Unlock Relay from the Junction Block.
Using a 12-volt test light connected to ground, check the Door Unlock Relay Output circuit (cavity 30) in the relay connector.
With the DRBIII®, actuate the Door Lock Relay.
Does the test light illuminate brightly when the relay is actuated?
Yes --> Replace the Door Unlock Relay.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Repair the Door Unlock Relay Output circuit for an open.
Perform BODY VERIFICATION TEST - VER 1  .
All