Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - DIMMING LEVEL SWITCH INPUT CIRCUIT HIGH
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, clear all BCM DTC's. Actuate the Dimming Level Switch. With the DRBIII®, read the DTC information. Does the DRBIII® read: Dimming Level Switch Input CKT High? Yes --> Go To 2 No --> The condition is not present at this time. Monitor DRBIII parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins that may apply. Visually inspect the related wiring harness and connector terminals. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Turn the ignition off. Disconnect the BCM C2 harness connector. Turn the ignition on to check the Courtesy Lamp operation. Did the Courtesy Lamps come on? Yes --> Go To 3 No --> Repair the Panel Lamps Dimmer Switch MUX circuit for an open condition. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 3 | Ensure the Junction Block C24 harness connector on the front of the junction block is connected. Turn on all overhead, map and rear rearing lamps by their own individual switches. This will disconnect each lamp from the Courtesy Lamp Driver Circuit. Did any lamp fail to light when it was turned on by it's own switch? Yes --> Repair the short to battery condition. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 4 |
All |
| 4 | Turn the ignition off. Disconnect the Junction Block C24 harness connector from the front of the junction block. Remove the Body Control Module from the junction block. Measure the voltage of the Courtesy Lamps Driver circuit. Is there any voltage on the Courtesy Lamps Driver Circuit? Yes --> Replace the Multifunction Switch. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |