Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - VTSS INDICATOR INOPERATIVE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
Ensure that the VTSS is enabled before proceeding with this test. Turn the ignition on.With the DRBIII®, read Body Control Module and Intrusion Transceiver Module DTCs.Does the DRBIII® display any DTCs?Yes --> Refer to the VEHICLE THEFT / SECURITY CATEGORY and perform the appropriate symptom.No --> Go To 2 |
All |
| 2 | Turn the ignition off. Disconnect the BCM C1 harness connector. Measure the voltage between the VTSS Indicator Driver circuit and ground. Is the voltage above 10.5 volts? Yes --> Replace and program the Body Control Module in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Turn the ignition off. Disconnect the Instrument Cluster Harness connector. Disconnect the BCM C1 harness connector. Measure the resistance of the VTSS Indicator Driver circuit. Is the resistance above 5.0 ohms? Yes --> Repair the VTSS Indicator Driver circuit for an open. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace and configure the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . |
All |