Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - SEATBELT LAMP CIRCUIT OPEN
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
The Instrument Cluster performs internal tests on the MIL, Seatbelt, Brake, ABS, and Airbag indicators during each ignition cycle. Instrument Cluster LEDs are not serviceable. With the DRBIII®, erase DTCs.Cycle the ignition and wait approximately 1 minute.With the DRBIII®, read DTCs.Did the Indicator lamp circuit Open or Short DTC reset?Yes --> Replace and configure the Instrument Cluster in accordance with the Service Information.Perform BODY VERIFICATION TEST - VER 1 .No --> Test Complete. |
All |