Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - REAR FOG RELAY CIRCUIT LOW
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRBIII®, clear all BCM DTC's. Turn the Fog Lamps on. With the DRBIII®, read the DTC information. Does the DRBIII® read: Rear Fog Relay Circuit Low? Yes --> Go To 2 No --> The condition is not present at this time. Monitor DRBIII parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins that may apply. Visually inspect the related wiring harness and connector terminals. Perform BODY VERIFICATION TEST - VER 1 . |
All |
| 2 | Turn the ignition off. Disconnect the Rear Fog Relay. Measure the resistance between ground and the Rear Fog Relay Control circuit. Is the resistance below 5.0 ohms? Yes --> Repair the Rear Fog Relay Control circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | Turn the ignition off. Disconnect the Rear Fog Relay harness connector from the Junction Block. Measure the voltage of the Rear Fog Relay harness connector coil side feed circuit to ground. Is the voltage above 10.0 volts? Yes --> Replace the Rear Fog Lamp Relay. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |