Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - LEFT REAR DOOR AJAR CIRCUIT SHORTED TO GROUND
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | With the DRBIII® in Inputs/Outputs, read the LR DOOR AJAR SW state. While monitoring the DRBIII®, disconnect the Left Rear Door Ajar Switch harness connector. Did the Switch State change from CLOSED to OPEN? Yes --> Replace the Left Rear Door Ajar Switch. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Disconnect the Left Rear Door Ajar Switch harness connector. Disconnect the BCM C2 harness connector. Using a 12-volt test light connected to 12-volts, probe the Sense circuit and test for a short to ground. Does the test light illuminate? Yes --> Repair the Left Rear Door Ajar Switch Sense circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |