Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - LEFT FRONT DOOR AJAR CIRCUIT SHORTED TO GROUND
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 |
NOTE:
For the Left Front Door Ajar state the DRBIII will read "PASS" for RHD. With the DRBIII® in Inputs/Outputs, read the DR or PASS DOOR AJAR SW state.While monitoring the DRBIII®, disconnect the Left Front Door Ajar Switch harness connector.Did the Switch State change from CLOSED to OPEN?Yes --> Replace the Left Front Door Ajar Switch.Perform BODY VERIFICATION TEST - VER 1 .No --> Go To 2 |
All |
| 2 | Disconnect the Left Front Door Ajar Switch harness connector. Disconnect the BCM C1 harness connector. Using a 12-volt test light connected to 12-volts, probe the Sense circuit and test for a short to ground. Does the test light illuminate? Yes --> Repair the Left Front Door Ajar Switch Sense circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1 . No --> Replace the Body Control Module. Perform BODY VERIFICATION TEST - VER 1 . |
All |