LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Door Ajar >> Symptom: *FLIP-UP GLASS AJAR CIRCUIT SHORTED TO GROUND >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - *FLIP-UP GLASS AJAR CIRCUIT SHORTED TO GROUND

TEST ACTION APPLICABILITY
1 With the DRBIII® in Inputs/Outputs, read the FLIP-UP AJAR SW state.
Disconnect the Tailgate Flip-up Glass Ajar Switch harness connector.
With the DRBIII® in Inputs/Outputs, read the FLIP-UP AJAR SW state.
Does the Switch State change from CLOSED to OPEN?
Yes --> Replace the Flip-up Glass Ajar Switch.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Go To 2		 All
2 Disconnect the Body Control Module C1 harness connector.
Disconnect the Tailgate Flip-up Glass Ajar Switch harness connector.
Using a 12-volt Test Light connected to 12-volts, test the Sense circuit for a short to ground.
Does the Test Light illuminate?
Yes --> Repair the Flip-up Glass Ajar Switch Sense circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1  .		 All
scientia non olet · About LEMON Manuals