LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Communication >> Symptom: ITM MESSAGES NOT RECEIVED >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - ITM MESSAGES NOT RECEIVED

TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRB, enter Theft Alarm then Intrusion Module.
Was the DRB able to I/D or communicate with the Intrusion Module?
Yes --> Go To 2
No --> Refer to the COMMUNICATION CATEGORY  for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1  .		 All
2 With the DRB, erase DTC's.
Turn the ignition on and wait approximately 1 minute.
With the DRB, read DTC's.
Did this DTC reset?
Yes --> Replace the Body Control Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Test Complete.		 All
scientia non olet · About LEMON Manuals