LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Communication >> Symptom: EEPROM CHECKSUM FAILURE >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - EEPROM CHECKSUM FAILURE

TEST ACTION APPLICABILITY
1 Connect the DRB to the Data Link Connector.
Turn the ignition on.
With the DRB, erase BCM DTC's.
Turn the ignition off then turn the ignition on.
With the DRB, read BCM DTC's.
Did this DTC reset?
Yes --> Reflash or Replace the Body Control Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1  .
No --> Test Complete.		 All
scientia non olet · About LEMON Manuals