Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - OCCUPANT CLASSIFICATION MODULE DATA TRANSFER ERROR
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on.
NOTE:
Ensure the battery is fully charged.
NOTE:
For the purpose of this test, the AECM and ORC modules will be referred to as an ACM.
NOTE:
Repair all of the other OCM active DTCs before attempt the repair.
NOTE:
Repair all of the other ACM active DTCs before attempt the repair. SELECT ACTIVE or STORED DTC: ACM - ACTIVE DTC Go To 2 ACM - STORED DTC Test Complete.
NOTE:
When reconnecting Airbag system components, the ignition must be turned off and the battery must be disconnected.
|
All |
| 2 | With the DRBIII®, ensure PCI Bus communications with the Airbag Control Module. Is the Airbag Control Module communicating on the PCI Bus? Yes --> Go To 3 No --> Refer to NO RESPONSE FROM OCM or OCM BUS +/- SIGNAL OPEN. |
All |
| 3 |
WARNING:
TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING:
IF THE OCCUPANT CLASSIFICATION MODULE IS DROPPED AT ANY TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND PERSONAL INJURY OR DEATH. If there are no possible causes remaining, view repair.Repair:Replace the OCS Bladder and Cushion Kit in accordance with service information. Then perform the Verification Required test to remove DTC created by the repair.Perform AIRBAG VERIFICATION TEST - VER 1 . |
All |