LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Body Diagnostic Procedures) >> Diagnostic Information And Procedures >> Airbag >> Symptom: *AIRBAG INDICATOR ON WITHOUT ACTIVE TROUBLE CODES >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE - *AIRBAG INDICATOR ON WITHOUT ACTIVE TROUBLE CODES

TEST ACTION APPLICABILITY
1
NOTE: Ensure the battery is fully charged.
Turn the ignition on.Make sure that all active DTC's have been repaired before performing this procedure.With the DRBIII® select the PASSIVE RESTRAINTS, AIRBAG, MONITOR DISPLAY and read the WARNING LAMP STATES.With no active DTCs, Does the LAMP REQ by ACM monitor show ON?Yes --> Replace the Airbag Control Module in accordance with Service Instructions.Perform AIRBAG VERIFICATION TEST - VER 1  .No --> Refer to INSTRUMENT CLUSTER CATEGORY  for problems related to Instrument Cluster.Perform AIRBAG VERIFICATION TEST - VER 1  .
NOTE: When reconnecting Airbag system components, the ignition must be turned off and the battery must be disconnected.
 All
scientia non olet · About LEMON Manuals