Diagnostic Procedure
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - P0685-ASD RELAY CONTROL CIRCUIT SHUTS OFF TOO LATE
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Turn the ignition on. With the DRB, check for additional DTCs. Are other DTCs present? Yes --> Refer to other DTCs before continuing. Perform ROAD TEST VERIFICATION - VER-2 . No --> Go To 2 |
All |
| 2 |
NOTE:
If the ECM detects and stores a DTC, the ECM also stores the engine/vehicle operating conditions under which the DTC was set. Some of these conditions are displayed on the DRB at the same time the DTC is displayed.
NOTE:
Before erasing stored DTCs, record these conditions. Attempting to duplicate these conditions may assist when checking for an active DTC. Turn the ignition on.With the DRB, erase ECM DTCs.Perform several ignition key cycles , pausing for at least 10 seconds between each cycle.Turn the ignition on.With the DRB, read ECM DTCs.Did this DTC set again?Yes --> Go To 3No --> Go To 6 |
All |
| 3 | Turn the ignition off. Install a substitute relay in place of the ASD Relay. Turn the ignition on. With the DRBIII®, erase DTCs. Perform several ignition key cycles , pausing for at least 10 seconds between each cycle. Turn the ignition on. With the DRB, read ECM DTCs. Did this DTC set again? Yes --> Go To 4 No --> Replace the ASD Relay. Perform ROAD TEST VERIFICATION - VER-2 . |
All |
| 4 | Turn the ignition off. Remove the ASD Relay from the PDC. Disconnect the ECM harness connectors. Measure the resistance between ground and the ASD Relay Control circuit while wiggling the wiring harness and connectors. Was the resistance below 1000 ohms at any time while wiggling the wiring harness and connectors? Yes --> Repair the ASD Relay Control circuit for an intermittent short to ground. Perform ROAD TEST VERIFICATION - VER-2 . No --> Go To 5 |
All |
| 5 | Turn the ignition off. Remove the ASD Relay from the PDC. Turn the ignition on. Measure the voltage of the ASD Relay Output circuit. Is the voltage below 0.5 volt? Yes --> Replace and program the Engine Control Module in accordance with the Service Information. Perform ROAD TEST VERIFICATION - VER-2 . No --> Repair the ASD Relay Output circuit for a short to voltage. Perform ROAD TEST VERIFICATION - VER-2 . |
All |
| 6 |
WARNING:
WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE:
The conditions that set the DTC are not present at this time. The following list may help in identifying the intermittent condition. With the engine running at normal operating temperature, monitor the DRB parameters related to the DTC while wiggling the wiring harness. Look for parameter values to change and/or a DTC to set.Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the conditions under which the DTC was set.Refer to any Technical Service Bulletins (TSB) that may apply.Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.Were any of the above conditions present?Yes --> Repair as necessary.Perform ROAD TEST VERIFICATION - VER-2 .No --> Test Complete. |
All |