Section 506 (Rack & Pinion Power Steering System): Pump: Pump: Installation: 3.7L
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - MOUNTING BOLTS |
| 2 - RESERVOIR |
| 3 - STEEL PULLEY |
- Install the pump to the vehicle.
- Install the three bolts (1) securing the pump to the engine Tighten the bolts to 47 N.m (35 ft.lbs.). See Fig 1.
- Install the power steering hoses.
- Install the serpentine belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
- Install the fan shroud
- Install the engine cooling fan (Refer to COOLING/ENGINE/RADIATOR FAN - INSTALLATION) .
- Install the radiator crossmember (Refer to BODY/EXTERIOR/RADIATOR CROSSMEMBER - INSTALLATION) .
- Refill the power steering fluid and check for leaks (Refer to STEERING/PUMP - STANDARD PROCEDURE) .