LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Powertrain Diagnostic Procedures - Diesel) >> Diagnostic Information And Procedures >> DRIVEABILITY - Diesel - Diagnostic Tests >> P0700-TCM DTC >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURES - P0700-TCM DTC

TEST ACTION APPLICABILITY
1
NOTE: If the ECM detects and stores a DTC, the ECM also stores the engine/vehicle operating conditions under which the DTC was set. Some of these conditions are displayed on the DRB at the same time the DTC is displayed.
NOTE: Before erasing stored DTCs, record these conditions. Attempting to duplicate these conditions may assist when checking for an active DTC.
NOTE: This code was set in the ECM by the Transmission Control Module to indicate a transmission fault. Diagnosis of transmission faults should be done using TRANSMISSION DIAGNOSTIC PROCEDURES .
NOTE: When repairs have been completed, the ECM and TCM must have codes cleared.
Turn the ignition on.With the DRBIII®, erase ECM DTCs only.With the DRBIII®, read ECM DTCs.Are there any TCM DTCs present in the ECM?Yes --> Refer to TRANSMISSION  Diagnostic Information for the related symptom(s).No --> Test Complete.		 All
scientia non olet · About LEMON Manuals