LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler X, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster >> Base Trim >> Installation - Base Trim

Installation - Base Trim

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. SEE AIR BAG RESTRAINT SYSTEMS ARTICLE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Position the base trim onto the instrument panel structural support.
  2. Install and tighten all of the screws around the perimeter of the instrument panel that secure the base trim to the structural support. Tighten the screws to 2 N.m (20 INCH lbs.).
  3. Install and tighten the two screws that secure the 16-way data link connector to the instrument panel. Tighten the screws to 2 N.m (20 INCH lbs.).
  4. Reinstall the passenger airbag door into the instrument panel. See AIR BAG RESTRAINT SYSTEMS .
  5. Reinstall the instrument panel into the vehicle. See INSTRUMENT PANEL ASSEMBLY  .
  6. Reinstall the outboard heater-A/C panel outlet barrels into the instrument panel. See MANUAL A/C-HEATER SYSTEMS article.
  7. Reinstall the heater-A/C control into the instrument panel. See MANUAL A/C-HEATER SYSTEMS article.
  8. Reinstall the radio into the instrument panel. See AUDIO/VIDEO article.
  9. Reinstall speakers into the instrument panel. See AUDIO/VIDEO article.
  10. Reinstall the grab handle bezel onto the instrument panel. See GRAB HANDLE  .
  11. Reinstall the accessory switch bezel onto the instrument panel. See ACCESSORY SWITCH BEZEL  .
  12. Reinstall the instrument cluster into the instrument panel. See INSTRUMENT CLUSTER  .
scientia non olet · About LEMON Manuals