LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler X, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Verification Tests >> Body Verification Test

Body Verification Test

BODY VERIFICATION TEST

BODY VERIFICATION TEST  APPLICABILITY
  1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
    2. NOTE: If the SKIM or PCM was replaced, refer to the service information for proper programming procedures.
  2. NOTE: If the MIC was replaced, configure new cluster with Tire Size, Axle, T-Case Type, and EQ Setting.
  4. Ensure all accessories are turned off and the battery is fully charged.
  5. With the DRBIII®, record and erase all DTC's from ALL modules. Start and run the engine for 2 minutes. Operate all functions of the system that caused the original concern.
  6. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII®, read DTC's from ALL modules.

    Are any DTCs present or is the original condition still present?

    1. Yes : Repair is not complete, refer to the appropriate symptom.
    2. No : Repair is complete.
 All
scientia non olet · About LEMON Manuals