LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Sport, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Overhaul - NV241 Transfer Case) >> Vehicle Speed Sensor >> Installation

Vehicle Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install sensor into transfer case rear extension and install mounting bolt. Before tightening bolt, verify speed sensor is fully seated (mounted flush) to rear extension.
  2. Tighten sensor mounting bolt to 11-16 N.m (8-12 ft. lbs.) torque.
  3. Connect electrical connector to sensor.
scientia non olet · About LEMON Manuals