LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Sport, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Overhaul - NV241 Transfer Case) >> Rear Extension Seal >> Removal

Rear Extension Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support vehicle.
  2. Remove rear propeller shaft. (Refer to PROPELLER SHAFT article.)
  3. Remove the rear companion flange from the output shaft.
  4. Using a suitable pry tool or slide-hammer mounted screw, remove the rear extension seal.
scientia non olet · About LEMON Manuals