LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Sport, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Overhaul - NV241 Transfer Case) >> Position Sensor >> Installation

Position Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the o-ring seal on the transfer case position sensor. Replace the o-ring if necessary.
  2. Install the transfer case position sensor into the transfer case. Torque the sensor to 20-34 N.m (15-25 ft.lbs.).
  3. Engage the transfer case position sensor connector to the position sensor.
  4. Lower vehicle.
  5. Verify proper sensor operation.
scientia non olet · About LEMON Manuals