LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Sport, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster >> Instrument Cluster >> Disassembly - Instrument Cluster >> Cluster Housing Rear Cover

Cluster Housing Rear Cover

  1. Disconnect and isolate the battery negative cable.
  2. Remove the instrument cluster from the instrument panel. See INSTRUMENT CLUSTER  .
  3. Remove the screw adjacent to each of the two cluster connector receptacles that secure the rear cover to the cluster housing.
  4. Work around the perimeter of the cluster housing rear cover and disengage each of the eight latches that secure the cover to the outside of the cluster housing. See Figure .
  5. Disengage the one inboard latch located in a receptacle near the lower edge of the rear cover just to the right of center that secures the rear cover to the cluster housing.
  6. Gently pull the cluster housing rear cover away from the back of the cluster housing.
scientia non olet · About LEMON Manuals