LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster >> Accessory Switch Bezel >> Installation - Accessory Switch Bezel

Installation - Accessory Switch Bezel

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. SEE AIR BAG RESTRAINT SYSTEMS ARTICLE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Position the accessory switch bezel to the instrument panel.
  2. Reconnect the instrument panel wire harness connectors to the connector receptacles for the accessory switches and the cigar lighter/power outlet on the back of the accessory switch bezel.
  3. Position the accessory switch bezel onto the instrument panel.
  4. Install and tighten the four screws that secure the accessory switch bezel to the instrument panel. Tighten the screws to 2 N.m (20 INCH lbs.).
  5. Reinstall the center bezel onto the instrument panel. See CLUSTER BEZEL  .
scientia non olet · About LEMON Manuals