LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *"NO FUSE" IN VF DISPLAY >> Diagnostic Procedure

Diagnostic Procedure

"NO FUSE" IN VF DISPLAY - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Inspect the #24 fuse in the Power Distribution Center.
If the fuse is open, replace with proper rated fuse.
Turn the ignition on for one minute.
Turn the ignition off.
Inspect the #24 fuse in the Power Distribution Center.
Is the fuse open?
  1. Yes : Repair the Fused B(+) circuit for a short to ground.

    Perform BODY VERIFICATION TEST .

  2. No : Go To 2
 All
2 Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Check connectors - Clean/repair as necessary.
Measure the voltage between the Fused B(+) circuit and ground.
Is the voltage above 10.5 volts?
  1. Yes : Replace and configure the Instrument Cluster in accordance with the Service Information.

    Perform BODY VERIFICATION TEST .

  2. No : Repair the Fused B(+) circuit for an open.

    Perform BODY VERIFICATION TEST .

 All
scientia non olet · About LEMON Manuals