LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Chime >> Symptom: *CHIME INOPERATIVE WITH DRIVER SEAT BELT UNFASTENED >> Diagnostic Procedure

Diagnostic Procedure

CHIME INOPERATIVE WITH DRIVER SEAT BELT UNFASTENED - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Ensure the drivers seat belt is unfastened.
With the DRB III select: Electro Mech Cluster Input Output.
Turn the ignition on.
Read the Driver Belt SW status.
Does the DRB III show Driver Belt SW: CLOSED?
  1. Yes : Go To 2
  2. No : Replace the Instrument Cluster.

    Perform BODY VERIFICATION TEST .

 All
2 Disconnect the Seat Belt Switch connector.
With the DRB III select: Electro Mech Cluster Input Outputs.
Turn the ignition on.
Read the Driver Belt SW status.
Does the DRB III show Seat Belt SW: CLOSED?
  1. Yes : Go To 3
  2. No : Repair Seat Belt switch pigtail wiring for a short to ground or replace the Seat Belt buckle assembly.

    Perform BODY VERIFICATION TEST .

 All
3 Turn the ignition off.
Remove the Instrument Cluster from the instrument panel.
Disconnect the Seat Belt Switch connector.
Measure the resistance between ground and the Seat Belt Switch Sense circuit at the Instrument Cluster C2 connector.
Is the resistance below 100.0 ohms?
  1. Yes : Repair the Seat Belt Switch Sense wire for a short to ground.

    Perform BODY VERIFICATION TEST .

  2. No : Go To 4
 All
4 If there are no possible causes remaining, view repair.
  1. Repair:Replace the Instrument Cluster.

    Perform BODY VERIFICATION TEST .

 All
scientia non olet · About LEMON Manuals