LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Rubicon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Overhaul - NV231 Transfer Case) >> Vehicle Speed Sensor >> Installation

Vehicle Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean inside of speedometer pinion gear adapter before installing speed sensor.
  2. Install sensor into speedometer gear adapter and install mounting bolt. Before tightening bolt, verify speed sensor is fully seated (mounted flush) to speedometer pinion gear adapter.
  3. Tighten sensor mounting bolt to 2.2 N.m (20 in. lbs.) torque.
  4. Connect electrical connector to sensor.
scientia non olet · About LEMON Manuals