LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Rubicon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Overhaul - NV231 Transfer Case) >> Speedometer Drive Adapter >> Removal

Speedometer Drive Adapter: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Raise vehicle.
  2. Disconnect wires from vehicle speed sensor.
  3. Remove adapter clamp and screw.
    Fig 1: Removing Speedometer
    G01708036Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove speed sensor and speedometer adapter as an assembly.
  5. Remove speed sensor retaining screw and remove sensor from adapter.
  6. Remove speedometer pinion from adapter. Replace pinion if chipped, cracked, or worn.
  7. Inspect sensor and adapter O-rings. See Fig 1. Remove and discard O-rings if worn or damaged.
  8. Inspect terminal pins in speed sensor. Clean pins with Mopar® electrical spray cleaner if dirty or oxidized. Replace sensor if faulty, or if pins are loose, severely corroded, or damaged.
scientia non olet · About LEMON Manuals