LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2004 >> Wrangler Rubicon, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *VF ODOMETER INOPERATIVE WITH DOOR OPEN >> Diagnostic Procedure

Diagnostic Procedure

VF ODOMETER INOPERATIVE WITH DOOR OPEN - DIAGNOSTIC PROCEDURE

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Inspect the #4 fuse in the Fuse Block.
If the fuse is open, replace with proper rated fuse.
NOTE: Ensure that the ignition is in the off position.

Open the door(s).
Inspect the #4 fuse in the Fuse Block.
Is the fuse open?
  1. Yes : Go To 2
  2. No : Go To 3
 All
2 Turn the ignition off.
Disconnect the Instrument Cluster C2 harness connector.
Check connectors - Clean/repair as necessary.
Measure the voltage between the Door Ajar Switch Sense circuit and ground.
NOTE: This test will work for either the Driver or Passenger Door Ajar Switch Sense circuit.

Is there any voltage present?
  1. Yes : Repair the Door Ajar Switch Sense circuit for a short to voltage.

    Perform BODY VERIFICATION TEST .

  2. No : Go To 3
 All
3 Turn the ignition off.
Disconnect the Door Ajar Switch harness connector.
NOTE: This test will work for the Driver or Passenger Door Ajar Switch.

Connect a jumper wire between cavity 1 and cavity 3.
Does the VF Odometer illuminate?
  1. Yes : Replace the inoperative Door Ajar Switch in accordance with the Service Information.

    Perform BODY VERIFICATION TEST .

  2. No : Go To 4
 All
4 Turn the ignition off.
Disconnect the Door Ajar Switch harness connector.
Connect a jumper wire between the Door Ajar Switch Sense circuit and ground.
NOTE: This test will work for the Driver or Passenger Door Ajar Switch Sense circuit.

Does the VF display illuminate?
  1. Yes : Go To 5
  2. No : Repair the Door Ajar Switch Sense circuit for an open.

    Perform BODY VERIFICATION TEST .

 All
5 Turn the ignition off.
Disconnect the Door Ajar Switch harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Door Ajar Switch Ground circuit.
NOTE: This test will work for the Driver or Passenger Door Ajar Switch.

Is the resistance below 5.0 ohms?
  1. Yes : Replace the Instrument Cluster in accordance with the Service Information.

    Perform BODY VERIFICATION TEST .

  2. No : Repair the Door Ajar Switch Ground circuit for an open.

    Perform BODY VERIFICATION TEST .

 All
scientia non olet · About LEMON Manuals