LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2003 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Removal & Installation >> Combination Valve >> Removal & Installation

Removal & Installation

  1. Remove brakelines connecting master cylinder to combination valve. Combination valve is located below master cylinder. Disconnect brakelines connecting combination valve to front and rear brakes. Disconnect wire from combination valve switch. Do not damage lock tabs on connector.
  2. Remove nuts attaching combination valve with bracket to power booster studs. Remove valve with bracket from power booster studs. To install, reverse removal procedure. Tighten brakelines to specification. See TORQUE SPECIFICATIONS  . Bleed brake system. See BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals