LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2003 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Overhaul >> Master Cylinder >> Fluid Reservoir & Grommets

Fluid Reservoir & Grommets

  1. Remove reservoir cap and empty brake fluid. Disconnect fluid level switch connector (if equipped). Using a pin punch and hammer, remove roll pins. Place master cylinder in a soft-jaw vise.
  2. Loosen reservoir from grommets with a pry tool. Rock reservoir side-to-side while pulling up, and remove from grommets. Remove grommets from master cylinder body. Lubricate new grommets with clean brake fluid. Using only finger pressure, install and seat grommets.
  3. Start reservoir in grommets. Rock reservoir side-to-side while pressing downward to seat reservoir into grommets. Install roll pins. Reconnect fluid level switch connector (if equipped). Fill reservoir and bench bleed master cylinder. See MASTER CYLINDER BLEEDING  under BLEEDING BRAKE SYSTEM.
scientia non olet · About LEMON Manuals